Replacing the Hole Puncher

There are two types of Hole Punch modules available with the Multifunction Finisher Pro Plus: a 2/3 or a 2/4 hole punch.

The Hole Punch module is first installed and set up on the system by a Xerox CSE. If you would like to switch to using the other type of hole puncher at any time, you must contact your Xerox representative who can order the 2/3 or 2/4 Hole Punch module. Once ordered and the CSE has completed running the NVM setup routine for the new hole punch module, you can then install and replace your current hole punch (for instance, 2/3) with the other hole punch (2/4).

To Replace the Hole Punch Module

See Contacting Xerox to get the correct part order number for this unit.

Make sure there are no jobs running. Also, you can refer to the label on the inside of the MFF Insertion Module cover door for removal instructions.

1. Open the front access cover of the MFF Insertion Module and locate the hole puncher.
2. Locate the black handle with the orange strip.
3. Remove the hole punch module by lifting the handle upwards and pulling straight out until you hear a click.
4. At the top of the hole punch module, grasp the long upper orange handle and, holding firmly, use the handle to slide and lift the module out.
5. Replace the new hole punch module. With the orange strip facing you and long orange handle on top, align the sides of the hole punch module against the MFF channel and slide it straight into the channel.
6. Completely insert the hole punch module until you hear a click.
7. Close the access cover of the MFF.