Replacing the Hole Punch Waste Container

When the Hole Punch Waste container in the Interface Module of the MultiFunction Finisher Pro Plus reaches its limit, an alert will appear in the system messages portion of the user interface screen.

Note

NOTE:A 90% full warning appears before the waste container is completely full. This gives you the opportunity to finish any jobs in progress. As soon as the job is printed, replace the waste container. If a full warning appears, the system will no longer punch jobs in progress until the waste container is emptied and replaced.

To replace the Hole Punch Waste Container

Make sure there are no jobs running.

  1. Open the front access cover of the MFF Insertion Module and locate the black waste container.
  2. Remove the waste container by grasping the black handle and sliding it straight out.
  3. Empty the waste container.
  4. Insert the empty waste container. Align the small black knobs on either side of the container on top of the metal brackets.
  5. Push the container in all the way until it stops, making sure it is completely seated.
  6. Close the access cover of the MFF.