Using "Build Job"

Note

NOTE: Copying and scanning jobs is not available on the Xerox Nuvera 288 Digital Perfecting System.

Build Job is used to combine multiple scans, each with different job programming, into a single, compiled output. Specifically, Build Job allows you to scan many different types of documents (either from the Document Feeder or the Document Glass) in separate jobs, then combine those separate scan jobs into one cohesive output.

Build Job is used to:

Note

NOTE: Build job applies to any type of scan job and does NOT apply to print jobs.

Before using Build Job, there are two concepts to understand. See Understanding Job and Segment Level Programming.

To use Build Job

  1. In the Xerox Nuvera user interface, click Copy, then click the <Build Job> button at the bottom left corner of the user interface. The system is now in Build Job mode.
  2. Place the first part of the document set (Job Segment 1) to be scanned in the Document Feeder or Document Glass.
    Note

    NOTE:At this point, perform any Job Level programming, since Job Level programming choices will be unavailable when scanning the remaining Job Segments.

  3. Once Job Level programming is complete for Job Segment 1, press <Continue>. The remainder of the tabs become enabled. Perform any Segment Level programming.
  4. When satisfied with your settings, click <Start>. Job Segment 1 begins scanning.
  5. When Job Segment 1 finishes, load the second part of the document set (Job Segment 2) to be scanned in the Document Feeder or Document Glass.
  6. Make any Segment Level programming. Remember, Job Level programming is already set, so all Job Level controls will be disabled.
  7. When satisfied with your settings, click <Start>. Job Segment 2 begins scanning.
  8. Load the next Job Segment, and perform steps 6, 7, and 8 for the remaining segments.
  9. To exit Build Job mode, click <End Build Job>. The job prints according to all of the Segment and Job Level programming.