Power Saver Mode
The capability to enter and exit Power Saver Modes is required to control power consumption during long periods of system inactivity and to comply with EPA's Energy Star® regulations for energy savings.
The system has three Power Saver modes:
- Low Power Mode (LPM)
- Monitor Off Mode (MOM)
- Sleep Mode (SM)
The monitor will shut off (black screen) when the machine goes into any of the Power Saver modes.
Table of operating modes
Configuration |
Low Power Mode (LPM) |
Monitor Off Mode (MOM) |
Sleep Mode (SM) |
||||
Power (Watts) |
Default Time |
Recovery Time |
Power (Watts) |
Default Time |
Power (Watts) |
Default Time |
|
Multifunction Copier/Printer 120ppm |
512 max |
<= 15 min. |
30 sec. |
N/A |
N/A |
105 max. |
<= 120 min. |
Power Saver Usage Guidelines/Tips
Power Saver modes and paper loading
When you are in Low Power Mode (LPM) or Sleep Mode (SM), the paper trays will not respond when you open/close/load them with paper. LPM or SM must be exited first, in order for the system to detect paper. However, you may load paper while you are in a Power Saver mode, and the paper will be detected after exiting Power Saver mode.
Ways to exit Low Power Mode
- Place document(s) in the Document Feeder
- Send a job from a client
- Requesting an exit from the UI. Choose [Printer: Exit Power Saver]
Ways to exit Sleep Mode
- Send a job from a client
- Requesting an exit from the UI. Choose [Printer: Exit Power Saver]
 |
NOTE: It is NOT possible to exit LPM or SM by simply moving the mouse or with keyboard strokes. However, moving the mouse will cause the system to exit MOM. |
|
NOTE: You cannot set the total of LPM and SM timers to more than 240 minutes. |
Refer to Xerox Nuvera online Help for details on configuring Power Saver Mode.
