Paper Through Document Feeder Performance Matrix
The Xerox Nuvera can process a wide array of stock types. Use the following topics to learn how each stock type can be expected to perform in the system.
TIP: If you're having feeding problems through the Document Feeder, all problems can be avoided by scanning directly from the Document Glass. |
Types and Conditions of Originals |
Rating |
Notes |
|
12 x 18 inch originals |
Do Not Feed |
A 12x18 inch original actually will travel through the Document Feeder, but there is a good chance some information on the output will be lost. To ensure all image information from a 12 x 18 inch original is captured, use the Document Glass. |
|
Coated paper |
Fair |
Feeding lightweight coated originals (approximately 16 lb. or 61 gsm) will normally work fine. You may experience problems with the alignment of the copy images if a color image is within 0.4 inches of the leading edge (the side of the document fed first) of the original. |
|
High Talc paper |
Good / Fair |
Originals with a high talc content may contaminate the Document Feeder Feed Rolls, resulting in degraded performance. |
|
Originals produced on a DocuTech 100/120 |
Fair |
On copies with a high-area coverage (pictures and halftones) tends to rub off on Feed Rolls, causing feeding faults. |
|
Originals produced on a DocuTech 100/120 |
Good / Fair |
Oils used to fuse the copies need to dry at least 2 hours in order to prevent feeding problems. |
|
Xerographic color originals |
Do Not Feed |
Use Document Glass to avoid feeding problems. |
|
Originals consisting of mostly pencil marks |
Do Not Feed |
Will transfer lead to the Feed Rolls, causing the originals to smear. Originals with occasional marks (i.e., a document with review markup) should feed satisfactorily. To avoid problems, feed all pencil-marked originals from the Document Glass. |
|
Dog-eared originals (folded corners) |
Do Not Feed |
Originals with dog-ears or folded corners on the lead edge may cause a jam. Ensure that the folds are removed. |
|
Too many sheets in the stack |
Do Not Feed |
Depending on the model, the Document Feeder can feed up to 300 sheets of 20 lb. paper. The quantity that can be fed decreases as paper weight increases. Use Build Job to feed more than these amounts as a single copy job. |
|
Folded originals |
Do Not Feed |
Folded originals do not trigger the automatic sensors in the Document Feeder. Ensure that the folds are removed. |
|
Originals with sticky-notes attached |
Do Not Feed |
May be fed after sticky notes removed. |
|
Envelopes |
Do Not Feed |
Copy from the Document Glass. |
|
Tab stock |
Do Not Feed |
Copy from the Document Glass. |
|
Labels |
Do Not Feed |
Copy from the Document Glass. |
|
GBC-brand papers |
Do Not Feed |
Copy from the Document Glass. |
|
Glossy photographs |
Do Not Feed |
Copy from the Document Glass. |
|
Transparencies |
Do Not Feed |
Copy from the Document Glass. |
Table Legend
SEF: Short Edge Feed
LEF: Long Edge Feed
Best: Best system performance
Good: Good system performance
Fair: Significant performance degradation is likely, particularly paper handling.
NR: Not Recommended. Exceeds system design. Unacceptable performance likely.
**: Same performance as shown in 20 lb. Standard Paper Table for the corresponding paper sizes.