Setting up a Print Job

The Xerox Nuvera offers a wide array of features to support your workflow needs. You can make a print using the default settings in either a client-based printer driver, or on the tabbed user interface. Or, you can use either of those methods to make changes to your document.

Explore the links at the left to learn more about ways to submit print jobs.

To set up a basic print job

  1. Submit a print job to the system using one of the methods (see the "Print My Document" links at left).
  2. Adjust the job properties under each tab.
  3. On the Basic tab, Choose paper to print on.
    Loaded Stock - you make a selection from the loaded stock list
    Stock List - you make a selection from the stock list
    Custom - you program a custom stock
    4. Note

    NOTE: If your job is in Job Manager, select the stock from Loaded Stock or Stock List under the Stock tab in the Job Properties window.
    Note

    NOTE: Choosing paper is not done on a "by tray" basis. For trays 1 and 2, if the same paper is loaded in both trays and tray 1 has a higher priority (a lower number), then it will feed from the highest priority tray.

    Additionally, if you loaded 8.5 x 11 inch paper in 2 trays (1 LEF and 1 SEF), you will see one choice for this paper, and 2 orientations to choose from in the Loaded Stock user interface.
  4. Load paper trays with appropriate stock(s) and adjust tray programming if necessary.
  5. Click <Print>.

See also:

For an overview of more sophisticated jobs and workflows, see Setup Complex Jobs.

For details about advanced features, see Use Advanced Features.