Stock Type

Common Uses

Recommendation

Note

Hole-Punched

Ringed binders

Use long edge feed for best copy speed (load with holes to the right).

Coated (not supported on MFF)

Presentations, collaterals

When printing on coated stock that has only one side coated, load the coated side UP.

Perforated

Pages for partial removal, such as order forms and receipts

Where possible, load with perforation parallel to the feed direction.

Pre-printed and letterhead

Common correspondence, mailings and advertising materials

• Use ultra-violet cured or oxidative inks to extend the life of the feed roll cartridges.
• Load face-up in Trays 1 - 4.

Reinforced Mylar edge

Ring binders

• Load reinforced edge on the right in Trays 1 - 4.
• Use long-edge feed only.

Card stock

Covers, signs

For best results, set Heavy Weight attribute when programming Trays 1 - 4.

Transparencies

Presentations

NOTE: The paper path/sensors in the Xerox Nuvera do not require that you feed transparencies with removable stripes. If you have this type of media, you can use it, but the stripe is not necessary for proper function.

NOTE: For dedicated transparency trays, first place approximately half an inch (12 mm) worth of plain paper at the bottom of the tray. This will ensure that all 50 of the transparencies get used.

• For all transparencies, refer to the label on the tray for correct orientation.
• When using transparencies with removable stripes, load with the stripe down in Tray 1 - 4.
• Do not program 2-sided.
• For best results, set Heavy Weight attribute when programming Trays 1 - 4.
• Nuvera supports only 8 1/2 x 11" (A4) transparencies.

Labels

Self-adhesive labels for envelopes and packaging

• Do not program 2-sided.
• For best results, feed labels into the machine LEF only.
• Load face-up in Trays 1 - 4.
• For best results, set Heavy Weight attribute when programming Trays 1 - 4.