Use the Postcard Bracket

Use the following procedure for installing and using the Postcard bracket when printing on smaller media, 101.6 x 152.4 mm (4 x 6 in.).

1. Pull out the tray slowly until it stops.
   
   
   
   

2. Move the paper guides out to the farthest positions.
   
   
   
   

3. To remove the postcard bracket, loosen the screw on the left side of the tray, then remove the bracket.
   
   
   
   

4. To install the postcard bracket:
   
   
   
   
   

5. 1. Place the bracket on the locating pins on the upper frame and in the grooves on the bottom of the tray.

   2. To lock the postcard bracket in place, tighten the thumbscrew.

6. Load the postcard stock SEF (short-edge feed) and against the right side of the tray.
   
   
   
   

7. Adjust the paper guides against the paper stock.
   
   
   
   

8. Close the paper tray. At the control panel touch screen, confirm the new settings.

9. Run your print job.

10. Upon completion of your print job, remove the postcard stock and the postcard bracket from the tray.

11. To store the postcard bracket, place the bracket in the storage area on the left side of the tray. Tighten the thumbscrew.