Skip to main contentClick to view our Accessibility Statement or contact us with accessibility-related questions.

Replace the Fuser Unit

Product support for
VersaLink C7000 Printer, VersaLink C7020/C7025/C7030 Multifunction Printer
Article ID
KB0134510
Published
2022-07-22

WARNING: The Fuser Unit may be very hot and should be handled with care! Use the lifting handle provided on the Top Cover to avoid any contact with hot surfaces during removal or replacement. Avoid any contact with internal parts of the unit.

  1. Power off the printer and allow it to cool down for at least 15 minutes. See the Related Content for additional information.

  2. Open the Bypass Tray (Paper Tray 5) by lowering it down.

    Open Bypass Tray

  3. Lift up on the release lever on Cover A to open the cover.

    Open Cover A

  4. Rotate the two screws that are securing the Fuser Unit to the left until they are completely loosened.

    Turn screws to the left

  5. Grasp the two ring tabs on the left and right side of the Fuser Unit, and then pull the unit out of the printer.

    Remove Fuser Unit

    NOTE: To return the used Fuser Unit for recycling, follow the instructions included with the new unit. If the instructions or shipping label are not available, click on the Recycling link under Related Content for additional information.

  6. Remove the new Fuser Unit from its packaging.

  7. Grasp the two ring tabs on the new unit, insert the unit into the printer, and then push it in until it locks into position.

    Insert new Fuser Unit

  8. Rotate the two securing screws to the right until both screws are tightened.

  9. Close Cover A.

  10. Close the Bypass Tray.

  11. Power on the printer.