Fault Code XOS-11-5140: Sheet on Turn Transport Middle Sensor
- Product support for
- Xerox iGen 5 Press
- Article ID
- KB0365551
- Published
- 2020-03-05
Open the far right hand door of the Stacker.
Near the bottom of the Area 3 Transport, you will see a purple, red and pink wire going to a sensor. Open the transport and locate the hole the sensor is mounted behind.
Using a fiberless swab, wipe the sensors off through the hole.
Using a fiberless wipe, wipe off the reflector opposite the hold on the stationary portion of the transport
Reset the fault.