Inserter Module Overview

Product support for: PrimeLink C9065/C9070 Printer
Article ID: KB0384536
Published: 2019-10-01

Overview of the Inserter Module

Note: This optional finishing accessory requires an Interface Decurler Module (IDM).

Use the inserter module to load media, such as blank, preprinted, or special stock, that you inserted into the finished output. The media serves as separators and covers for the finished output. The printer does not print media fed from the inserter module. Instead, the printer places media into the printed output at selected locations.

Note: Other names for the inserter include post-process inserter or interposer.

Inserter Module

Inserter Components

Tray T1 or Inserter Tray
Inserter Control Panel
Inserter Front Cover

Inserter Control Panel

Number	Component	Description
1	Paper Jam Error Indicator	When a paper jam occurs in the inserter, this indicator illuminates.
2	Curl Up and Down Indicators	Similar to the interface decurler module (IDM), these indicators show the direction of the curl correction. However, there are only three curl-correction options for the inserter: Upward curl correction is the top indicator. Downward curl correction is the bottom indicator. Off, or no curl correction, is the middle indicator.
Important: If paper curl continues after you set the curl-correction level to the highest or lowest setting on the IDM, use one of the following selections.
3	Manual Curl Upward	When the printed output is curled up, touch the curl-upward option.
4	Manual Curl Downward	When the printed output is curled down, touch the curl-downward option.
5	Auto Curl	Automatically corrects the paper curl by selecting the curl direction and amount.