Skip to main contentClick to view our Accessibility Statement or contact us with accessibility-related questions.

Crease and Two-Sided Trimmer Configuration and Components

Product support for
Xerox Iridesse Production Press
Article ID
KB0370660
Published
2018-10-12

The Crease and Two-Sided Trimmer trims the tops and bottoms of sheets or booklets to produce an even edge and a full bleed when combined with the SquareFold® Trimmer Module.

Note: This optional finishing device requires one of the following Production Ready Finishers:

  • Production Ready Finisher

  • Production Ready Booklet Maker Finisher

  • Production Ready Finisher Plus

The Crease and Two-Sided Trimmer is an optional finishing device that provides page creasing and trimming on two sides of the output.

The Crease and Two-Sided Trimmer performs the following tasks:

  • Trims 6–25 mm (0.24–0.99 in.) from the top and bottom of prints or booklets to produce an output with the appropriate finished width and appearance.

    Note:

    • If you crease the media within 62 mm of the lead edge, the chance of jams increases.

    • The lowest crease setting value of 1 may not produce any visible crease on some media.

  • Trims incoming media sizes 7.6 x 10.1 in. (194 x 257 mm) to 13 x 19.2 in. (330.2 x 488 mm)

  • Trims incoming media sizes 52–350 g/m2 or coated paper 106–350 g/m2

When paired with the SquareFold Trimmer, all sides of booklets can be trimmed except the binding, which enables full-bleed booklets.

Configuration:

The Crease and Two-Sided Trimmer trims the top and bottom edge of output media, applies creases in the vertical direction, and overlaps two sheets of output.

  1. Dust Box - The Dust Box stored trim waste.

  2. Trimmer - The Trimmer trims the top and/or bottom edges in the process direction.

  3. Creaser - The Creaser applies creases in the vertical direction.

  4. Registration - The Registration adjusts media skew and detects the position of the media.

  5. Bypass - The Bypass transports media through the remaining modules without providing finishing.

  6. Buffer - The Buffer overlaps two sheets of media to output.

 

Components:

Number

Component

Description

1

Stock Jam/Error Indicator

This indicator illuminates when a jam occurs.

If the indicator is blinking, you must clear the jam before printing can resume.

2

Trimmer Waste Container Full Indicator

This indicators illuminates when it is time to empty the Trimmer Waste Container and blinks when the container is full.

3

Upper Cover

Open this cover to clear jams.

4

Lower Cover

Open this cover to empty the Trimmer Waste Container.