Load Paper in the Oversized High-Capacity Feeder (OHCF) Tray 6
- Product support for
- Xerox Color 550/560/570 Printer
- Article ID
- KB0328789
- Published
- 2017-04-03
WARNING: Pull out the Oversize High Capacity Feeder (OHCF) Tray slowly to avoid injury.
Pull out the OHCF Tray until it stops.
NOTE: Do not pull out the tray while the machine is processing a job from this tray.Squeeze the handle on the paper edge guide (A), and slide the guide to the required paper size.
Squeeze the handle on the paper edge guide (B), and slide the guide to the required paper size.
Fan the sheets of paper before loading them into the OHCF Tray so that all four corners are aligned.
Load the paper with the side to be copied or printed face-up, and register the paper stack in the lower, right corner of the tray.
NOTE: Do not load paper above the maximum fill line. This may cause paper jams or machine malfunctions. When loading hole-punched (drilled) paper, place the paper with the hole side to the right. When loading tabbed stock, place the tabs to the left.Slide both paper edge guides to just touch the edges of the paper stack.
NOTE: Position the paper edge guides correctly to match the paper size. If the position of the paper edge guides are not correct, the paper may not be fed properly and paper jams may occur.
CAUTION: For paper heavier than 256 g/m2 (68 lb), slide both paper weight switches to the heavier weight position (257 g/m2 to 300 g/m2 or 68 lb to 80 lb). Failure to do so may result in paper jams.If necessary, move both paper weight switches to the appropriate positions.
Gently push the tray in until it comes to a stop.
NOTE: When the loaded tray is closed, the tray position is automatically adjusted in the front or back direction based on the paper size.