Skip to main contentClick to view our Accessibility Statement or contact us with accessibility-related questions.

Replace the Duplex Automatic Document Feeder (DADF) Feed Roller Kit

Product support for
WorkCentre 7830/7835/7845/7855
Article ID
KB0238031
Published
2025-01-08

NOTE: A Video and QR Code is available at the end of this solution.

 Remove the Old Rollers and Install the New Rollers:

    1. Power off the machine. See the Related Content for additional information.

    2. Open the Duplex Automatic Document Feeder (DADF) Top Cover. The feed rollers are located under the cover.





    3. Locate the Feed Roller Cover release clip above the rollers. Press the clip up and release the cover.





    4. At the Feed rollers, pull the grey lever up and unclip it from the machine.





    5. Slide both Feed Rollers to the left to remove them.



    6. Install the new Feed Rollers inserting the metal side first.





    7. Install the new grey lever and clip it back into position.





    8. Close the Feed Roller Cover.



Remove the Old Retard Rollers and Install the New Retard Rollers:

    1. Lift up the black retard roller holder to partly unclip it from the machine.



    2. Remove the Retard Roller from the machine and install the new Retard Roller.







    3. Push down on the black retard roller holder and clip it back into position.

    4. Lower the cover until it clicks into place to close the DADF top cover.

    5. Power on the machine. See the Related Content for additional information.
       

QR Code:

Feed Roll Replace

 Back To Top

Video:

Back To Top




Related Content