Skip to main contentClick to view our Accessibility Statement or contact us with accessibility-related questions.

Replace the Imaging Unit Kit

Product support for
WorkCentre 6605
Article ID
KB0230269
Published
2016-02-12

The Imaging Unit Kit includes 4 Imaging Units and a replacement felt cleaning rod head. Only replace the Imaging Unit Kit when told to replace the kit for a specific reason. All 4 Imaging Units and the felt cleaning rod pad should be replaced at the same time.

NOTE: The Imaging Unit Kit has a yield of approximately 60,000 pages; this can vary depending on type of use / coverage.

CAUTION: Do not use warm water or cleaning solvents to remove Toner (Dry Ink) from your skin or clothing. This will set the Toner and make it difficult to remove. If any Toner gets on your skin or clothing, use a brush to remove the Toner, or wash it off with cold water and mild soap.

For additional product and material safety information, click on [Xerox Environment, Health and Safety] in the Related Content section.

CAUTION: If the optional Productivity Kit (HD) is not installed, make sure the Ready LED is off before powering off the printer. The data in the memory is cleared when the printer is powered off.

  1. Power off the printer. See the Related Content section for additional information.

    Power switch

  2. Open the Right Side Door.

    Open right side door

  3. On the right side of the printer, unlock the Waste Cartridge, rotate the lever 90-degrees to the left.

    Unlock waste cartridge

  4. Grasp the handle of the Waste Cartridge, then pull the cartridge out of the printer. To prevent Toner spills, keep the openings in the cartridge, face-up. Place the Waste Cartridge on a level surface.

    Remove waste cartridge

    NOTE: Be careful not to spill Toner when handling the Waste Cartridge. After removing the cartridge, do not touch the Toner port.

    Waste cartridge

    CAUTION: To avoid Toner spills or malfunction, do not place the Waste Cartridge on the side.

  5. For each of the 4 Imaging Units:

    1. Grasp the tab, push down, and pull the unit straight out of the printer.

      Remove Imaging Unit

    2. Place the unit aside for recycling.

    3. Remove the new Imaging Unit from the packaging.

    4. Remove the film from the Imaging Unit.

    5. Push the new Imaging Unit into the printer until the unit clicks into place.

      CAUTION: Do not touch the top of the Imaging Unit. Do not expose the unit to light for more than 5 minutes.

  6. Remove the cleaning rod located below the black Imaging Unit inside the printer.

    Remove cleaning rod

  7. Remove the felt pad by squeezing the two tabs on the opposite side of the pad to release the pad from the rod. Dispose of the felt pad as normal office waste or recycle the pad in accordance with local regulations.

    Cleaning rod pad

  8. Remove the new felt pad from the packaging.

  9. Insert the new new felt pad into the rod.

    NOTE: There are four cleaning holes; one hole for each Toner (Dry Ink) color. From the front of the printer to the back, the corresponding colors are Yellow (Y), Magenta (M), Cyan (C), and Black (K).

  10. Insert the cleaning rod into one of the four cleaning holes until the rod clicks into position, then pull the rod out. Repeat this two more times.

    Clean laser lenses

  11. Repeat the cleaning process for the other three holes.

  12. Return the cleaning rod to the original location.

  13. Reinsert the Waste Cartridge.

    Reinsert waste cartridge

  14. To lock the Waste Cartridge, rotate the lever 90-degrees to the right. When the lever is vertical, the cartridge is locked in position.

    Lock waste cartridge

  15. Close the Right Side Door.

    Close right side door

  16. Power on the printer. See the Related Content section for additional information.




    Related Content