Skip to main contentClick to view our Accessibility Statement or contact us with accessibility-related questions.

Replace the Duplex Automatic Document Feeder (DADF) Feed Roller Assembly

Product support for
WorkCentre 6605
Article ID
KB0229159
Published
2016-02-10

Remove the old DADF Feed Roller Assembly:

  1. Power off the printer. See the Related Content section for additional information.

    Power switch

  2. Open the Duplex Automatic Document Feeder (DADF) Cover.

    Open Duplex Automatic Document Feeder top cover

  3. Locate the green lever on the left side of the DADF Feed Roller Assembly. 

    DADF Feed Roller Assembly lever

  4. Pull up on the green lever, then pull the assembly out of the printer.

    Remove DADF Feed Roller Assembly

Install the new DADF Feed Roller Assembly:

  1. Remove the new DADF Feed Roller Assembly from the package.

  2. Install the new Feed Roller Assembly into the printer.

    1. Insert the assembly into the printer and push the assembly against the rear bracket.

    2. Move the front of the assembly down into position.

    3. Lower the assembly into position while holding the lever at a 90 degree position.

  3. Close the DADF Cover.

  4. Power on the printer. See the Related Content section for additional information.




    Related Content