Replace a Toner (Dry Ink) Cartridge

Product support for: WorkCentre 6025
Article ID: KB0229037
Published: 2016-05-25

CAUTION:Do not use warm water or cleaning solvents to remove Toner (Dry Ink) from your skin or clothing. This will set the Toner and make it difficult to remove. If any Toner gets on your skin or clothing, use a brush to remove the Toner, or wash it off with cold water and mild soap.

Use of Toner other than Genuine Xerox Toner may affect print quality and printer reliability. It is the only Toner designed and manufactured under strict quality controls by Xerox for specific use with this printer.

NOTE: The Control Panel will indicate which Toner Cartridge needs to be replaced. Where indicated by; Cyan (C), Magenta (M), Yellow (Y), or Black (K).

Power off the printer by pressing the power switch to the off (O) position.

NOTE: The power switch is located on the right side of the printer.
Unplug the power cord.
As a precaution, place a few sheets of paper under the Toner Cartridge area to catch any Toner that may spill.
Open the Toner Access Cover.

WARNING: The Heat Roll and Fuser area may be very hot! Avoid any contact with internal parts of the printer.
Pinch the Toner Cartridge Release Lever upward, and then pull out slowly to remove the cartridge.
Set the cartridge on the paper with the label side down.

NOTE: Do not touch any Toner that may cling to the cartridge. Discard the old cartridge as normal office waste or recycle it.
Make sure that the new Toner Cartridge matches the color of the one just removed, and then remove the new cartridge from the packaging.
Remove the tape from the post on the back of the Toner Cartridge.
Gently shake the new cartridge five or six times to distribute the Toner evenly.
Align the Toner Cartridge to the slot by aligning the geared post with the hole, and then insert the cartridge firmly by pressing in on the center of the label until the cartridge clicks in place.
Close the Toner Access Cover.
Plug in the power cord.
Power on the printer.