Skip to main contentClick to view our Accessibility Statement or contact us with accessibility-related questions.

Replace the Booklet Staple Cartridge for Saddle Stitching

Product support for
PrimeLink B9100/B9110/B9125/B9136
Article ID
KB0092435
Published
2020-02-12

Note: A video is available at the end of this solution.

Note: Before performing this procedure, ensure that the printer is not printing.

Note: This procedure is applicable only to the PR Booklet Maker Finisher.

  1. Open the finisher front cover.

    Open the finisher front cover

  2. Pull out the Saddle Stitch Unit 3 toward you until it stops.

    Pull out the Saddle Stitch Unit 3 toward you until it stops

  3. To remove the staple cartridge, hold the tabs on the cartridge, then pull the cartridge out of the printer.

    Note: There are two booklet staple cartridges provided. The message on the printer control panel touch screen indicates which cartridge needs replacement.

    Remove the staple cartridge, hold the tabs on the cartridge, then pull the cartridge out of the printer

  4. While holding the tabs on the new staple cartridge, push in the cartridge until it stops.

    Note:  Ensure that the marks are aligned.



    While holding the tabs on the new staple cartridge, push in the cartridge until it stops

  5. Push the Saddle Stitch Unit 3 into the finisher gently, until the unit stops.

    Push the Saddle Stitch Unit 3 into the finisher gently, until the unit stops

  6. Close the finisher front cover.

Video: