Skip to main contentClick to view our Accessibility Statement or contact us with accessibility-related questions.

Clean the CTD / ADC Sensor Window

Product support for
Phaser 6500
Article ID
KB0092045
Published
2016-04-14

CAUTION: Do not use warm water or cleaning solvents to remove Toner (Dry Ink) from your skin or clothing. This will set the Toner and make it difficult to remove. If any Toner gets on your skin or clothing, use a brush to remove the Toner, blow it off, or wash it off with cold water and mild soap.

Do not expose the Imaging Unit to any light source for more than five minutes. Prolonged exposure to light may damage the unit. Cover the Imaging Unit with a light shield (such as a sheet of paper). Do not touch the shiny blue Transfer Belt.

  1. Power off the printer using the power switch located on the left side of the printer, toward the back. Press the power switch to the off (O) position.



  2. Power Off

  3. Press the button on the top, right side of the printer to open the Front Cover.



  4. Open Front Cover

  5. Lower the Transfer Belt.

    Lower Transfer Belt

  6. Locate the CTD / ADC sensor, inside the Front Cover, on the top, middle area of the Transfer Belt.



  7. Locate Sensor

  8. Gently wipe the CTD / ADC sensor window using a clean, dry cloth or cotton swab.



  9. Clean Sensor

  10. Close the Front Cover.



  11. Close Front Cover

  12. Power on (|) the printer. A 'Ready to Print' message will be displayed on the Display Screen.



  13. Power On