Skip to main contentClick to view our Accessibility Statement or contact us with accessibility-related questions.

Replace an Imaging Unit

Product support for
Phaser 7800
Article ID
KB0091038
Published
2016-11-10

  1. Open the Front Cover.

    Open Front Cover

  2. Locate the lock lever for the imaging unit cover, and then rotate the lever to the left to unlock the cover.

    Unlock Imaging Unit Cover

  3. Open the imaging unit cover.

    Open Imaging Unit Cover

  4. Grasp the end of the Imaging Unit to be replaced, and then pull the unit straight out of the printer.

    NOTE: Dispose of the unit as normal office waste or recycle it in accordance with local regulations.

    Remove the Imaging Unit

  5. Remove the new Imaging Unit from its packaging.

    Remove packing material

  6. Remove the protective packing material.

    Remove protective sheet

  7. Align the the Imaging Unit with the holes on the printer.

    Align Imaging Unit

  8. While supporting the bottom of the unit with one hand, use your other hand to push the tab to slide the Imaging Unit into the printer. Make sure to push the unit completely into the printer.

    Install Imaging Unit

  9. Close the imaging unit cover.

  10. Rotate the lock lever completely to the right to lock the cover in place.

    NOTE: If the lever is not completely in the locked position the Front Cover will not close.

  11. Close the Front Cover.