Skip to main contentClick to view our Accessibility Statement or contact us with accessibility-related questions.

Connect the Ethernet Cable to Enable Network Printing With the Phaser 4510

Product support for
Phaser 4510
Article ID
KB0047861
Published
2016-03-24

Ethernet can be used for one or more computers. It supports many printers and systems on an Ethernet network. An Ethernet connection is recommended because it is faster than a USB connection. It also allows direct access to CentreWare Internet Services (CWIS).

Depending on the printer setup, the following hardware and cabling is required for Ethernet setup.

  • If connecting to one computer, an Ethernet RJ-45 crossover cable is required.

  • If connecting to one or more computers with an Ethernet hub, or cable or DSL router, two or more twisted-pair (category 5/RJ-45) cables are required. (One cable for each device.)

If connecting to one or more computers with a hub, connect the computer to the hub with one cable, and then connect the printer to the hub with the second cable. Connect to any port on the hub except the uplink port.

  1. Power OFF the computer.

  2. Power OFF the printer. Press the power switch that is located on the front of the printer, on the bottom left side, to the (O) position.

    Power OFF

  3. Plug one end of the Ethernet cable into the Ethernet network port on the back of the printer.

    Network port

  4. Plug the other end of the cable into a network LAN connection.

  5. Power ON the printer and let it completely boot up.

    Power ON

  6. Power ON the computer.