Replace the Waste Toner (Dry Ink) Bottle
- Product support for
- Phaser 4600/4620, Phaser 4622
- Article ID
- KB0047137
- Published
- 2016-11-08
CAUTION: Do not use warm water or cleaning solvents to remove Toner from your skin or clothing. This will set the Toner and make it difficult to remove. If any Toner gets on your skin or clothing, use a brush to remove the Toner, or wash it off with cold water and mild soap.
NOTE: The Waste Toner Bottle must be replaced at the same time as the Toner Cartridge. See the Related Content for additional information on replacing the Toner Cartridge.
Remove the new Waste Toner Bottle from its packaging and set it aside.
Open the Waste Toner Bottle Access Door on the left side of the printer.
Grasp the Waste Toner Bottle and pull it out of the printer.
Place the used bottle into the plastic bag that the new bottle came in, and then seal the bag and place it in the empty box.
NOTE: To return the used Waste Toner Bottle for recycling, follow the instructions included with the new bottle. If the instructions or shipping label are not available, click on the [Recycling] link under the Related Content for additional information.Insert the new bottle into the printer.
Close the door.