Replace the Toner (Print) Cartridge
- Product support for
- Phaser 3052, Phaser 3260
- Article ID
- KB0036999
- Published
- 2016-04-25
When the Toner LED light on the Control Panel is solid orange, it is time to replace the Toner cartridge.
To replace the cartridge, follow the instructions provided below or with the consumable.
WARNING: When replacing consumables, do not remove the covers or guards that are fastened with screws. You cannot maintain or service any of the parts that are behind these covers and guards. Do not attempt any maintenance procedure that is not specifically described in the documentation supplied with your machine.
Open the Front Cover of the printer.
Pull out the Toner cartridge using the handle with the colored label.
Remove the new Toner cartridge from the packaging. Follow the packaging directions to remove the protective packaging materials from the cartridge.
Slowly shake the new cartridge five or six times to distribute the toner evenly inside the cartridge.
CAUTION: If Toner gets on your clothing, wipe it off with a dry cloth and wash clothing in cold water. Hot water sets Toner into fabric.Hold the Toner cartridge by the handle and slowly insert the cartridge into the opening in the machine. Tabs on the sides of the cartridge and corresponding grooves within the machine will guide the cartridge into the correct position until it locks into place.
Close the Front Cover. The Machine Status light will return to green, indicating the printer is ready. The Toner LED light should not be lit, indicating there is enough Toner to print.