Skip to main contentClick to view our Accessibility Statement or contact us with accessibility-related questions.

Replace the Toner (Dry Ink) Waste Container

Product support for
DocuTech 6100 Production Publisher, DocuTech 6115, DocuTech 6135, DocuTech 6155, DocuTech 6180
Article ID
KB0033394
Published
2015-09-01

NOTE: Old waste containers should not be emptied, cleaned and used again. There is a sensor inside the container that remains dirty and the machine will not recognize the container. The used module can be returned to Xerox for recycling using the shipping label found inside the box. Use the box that contained the module to return the item.

CAUTION: Do not use warm water or cleaning solvents to remove Toner from your skin or clothing. This will set the Toner and make it difficult to remove. If any Toner gets on your skin or clothing, use a brush to remove the Toner, or wash it off with cold water and mild soap.



To replace the Toner Waste Container:
  1. Open the Processor Doors.

  2. Locate the Toner Waste Container which is located directly under Area 6, near the floor.

  3. Place a drop cloth or a few sheets of paper on the floor under the Toner Waste Container area to catch any Toner that may spill.

  4. Grasp the tab on the Toner Waste Container and pull the container out of the machine, slowly.



    CAUTION: To prevent a Toner spill, do not tip or tilt the waste container.



  5. Remove the cap from the top of the full Toner Waste Container.



  6. Place the cap over the opening on the end of the full Toner Waste Container.



  7. Remove the new Toner Waste Container from the box.

  8. Slide the new Toner Waste Container all the way into the machine until the container stops.

    NOTE: You do not need to remove the cap from the storage position at this time.

  9. Close the Processor Doors.