Enable and Configure AirPrint on a Xerox Device

AirPrint is enabled on Xerox devices by default. If, however, AirPrint has been disabled on the Xerox device, an administrator can re-enable it following the steps below:

1. You will need the device IP address or DNS name to access the AirPrint configuration web interface from your browser. You can find the IP address at the device UI screen. From the device's Control Panel, go to the Machine Status menu and select the Machine Information tab. The IP address will be shown on this page, or you can select Informational Pages button and select and print the Configuration Report.

2. Open the Xerox device’s web interface by entering the IP address of the device into a web browser’s Address field (https://). This will open the web interface.

3. Click on the Properties tab (if necessary, enter credentials if prompted: default administrative user is: admin, password: 1111).

4. Select Connectivity > Setup. The Connectivity page will display in the right frame.

5. Under Protocols look for AirPrint. Select Edit on the AirPrint row. The AirPrint configuration page will open.

6. Under Protocol Settings, check the box under Protocol next to Enabled.
   
   NOTE: HTTP, IPP and mDNS all need to be enabled and configured for AirPrint to be enabled.
   
   

7. Configure a Device Name, Device Location and Geographic Location. These attributes distinguish the AirPrint printer as seen from the Apple iOS application.