Replace the Paper Tray 1 Support Arm
- Product support for
- ColorQube 8570, ColorQube 8580, ColorQube 8870, ColorQube 8880
- Article ID
- KB0027776
- Published
- 2016-11-01
To remove the old support arm:
Open Paper Tray 1 about a third of the way (30 degrees).
Push the old arm toward the tray to release it from the printer frame.
Rotate the arm so that it is perpendicular to the tray. (90 degrees).
Pull out on the arm to release it from the tray.
To install the new support arm:
With the arm perpendicular to the tray, slide the arm through the slot and onto the pin on the tray.
Rotate the arm toward the printer.
Raise the tray until it is a third of the way open (30 degrees).
Snap the arm into the hole in the printer frame.