Enable or Disable the Banner Sheet on a Fiery

Open an Internet browser window.

Enter the IP address of the Fiery Server in the Address field, and then press Enter on the keyboard. The Fiery WebTools window will be displayed.

NOTE: If necessary, print a System Settings (Configuration) Report to obtain the IP address.

Select the Configure tab.

Select the Launch Configure button. A login window will be displayed.

NOTE: The Administrator account is the only account available as it is mandatory to login as the Administrator.

Enter a password in the Password field, and then select OK. The Launch Configure screen will be displayed.

IMPORTANT: The Fiery documentation may mention “Fiery.1” as the default password. Do not use this password when you log on to the Fiery server for the first time. Instead, print a Fiery Server Configuration page and look for ID in the BIOS Setup section (listed under RIP).  For a stand-alone Fiery server, the default password is listed in the ID field. For the integrated Fiery server, the default password is the first 14 alphanumeric characters listed in the ID field. The password is case sensitive.

Note: If you reinstall the Fiery system software or restore factory default settings, the administrator password will be replaced by “Fiery.1”.  Use “Fiery.1” to log on to the Fiery server and then change the password to prevent unauthorized usage.
 
If problems with the password are encountered, contact your System Administrator for additional assistance.

Select PDL on the left side of the window to expand the menu.

Select PS.

Select On to enable the Cover / Banner page, or Off to disable the Cover / Banner page, from the Cover Page pull-down menu.

Select Apply.

Select Reboot to reboot the server and apply the changes. A confirmation window will be displayed.

Select Yes to reboot the server. A Please Wait message will be displayed.

Close all open windows.