Perform the Clean Toner Procedure
- Product support for
- Xerox Versant 180 Press, Xerox Versant 280 Press, Xerox Versant 3100 Press, Xerox Versant 4100 Press, Xerox Versant 2100 Press, Xerox Versant 80 Press
- Article ID
- KB0013969
- Published
- 2020-11-03
NOTE: A video is available at the end of this solution.
Use the Clean Toner Procedure after running a low area coverage job which was then followed by large area coverage job, and thereby experiencing toner agglomerates and clumps on the output prints. The press runs a full-page halftone to purge the debris and any residual dry ink / toner from the system.
Note: It is recommended that you run a few test prints before performing the cleaning procedure. After the Start Cleaning button is selected, the system automatically generates a test print. This allows you to compare the before and after prints for image quality.
Log in as the administrator. See the Related Content for additional information.
Press the Machine Status button on the UI.
Select the Tools tab.
Select System Settings > Common Service Settings > Maintenance.
Page down and select Clean Toner.
Select the desired dry ink / toner colors to be cleaned.
Select the desired percentage amount.
Select the desired Paper Supply.
Select the Start button to begin. When the process is complete, a message appears on the press UI.
Select Close repeatedly until the main Tools screen displays.
Exit the administrator mode.
Video: