Using the Basic Finishing Module (BFM)
The Basic Finishing Module (BFM) allows you to finish your jobs with features such as:
- Stapling
- High-capacity stacking
- Collating
What the LED means
LED is Off = Stacker is accepting sheets (Do not open BFM front door)
LED is Steady = Stacker tray is lowering (Do not open BFM front Door)
LED is Blinking = OK to open stacker door.
Selecting the BFM or BFM Plus finisher as the output device.
- Select the Output tab from a Job or Queue Properties window.
- Select [Stapling/Finishing: Output Location].
- Select [Finisher 'X'].
- Select either:
System Specified
Auto Switch
Main Stacker
Top Tray
BFM Stacker Settings
- Select [Print Manager: Stacking tab].
- Right click on <Finisher 'X'> and select Settings.
- Set Offset Stacking setting:
Enable Between Job Offsetting
Allow PDL Override - Set Unload After:
Job
Limit
Partition
Set
Job/Partition
BFM Stacker Limits
- Select [Print Manager: Stacking tab].
- Right click on <Finisher 'X'> and select Stacker Limits.
- Set Stacking Limits:
Main Stacker 200 - 3000 sheets
Bindexer Capacity 15 - 1000 sheets per unstapled set chunk (or leave blank for Automated Bindexer). The system uses the lower of the manual or automatic setting.
BFM Set Registration
- Select [Print Manager: Stacking tab].
- Right click on <Finisher 'X'> and select Stacker Limits.
- Set Set Registration Quality:
Improve Set Registration - improves curl with jobs that have two staples.
Improve Initial Pages Registration - improves curl within sets.
NOTE: When running smaller stapled sets (15 sheets or less), limit the quantity to 100 maximum. Unload the stacker after each quantity is completed. |
Explore the links below to learn all of the ways to utilize the BFM.
Delivering Document Sets to a Stacker